🛑 STOP Your ARTIFICIAL TURF from MELTING 🔥 Do-It-Yourself Window Film Solution 😎

Practical Ways to Repair Your Melted Vinyl Siding

Vinyl siding is considered as one of the most common types of home sidings because of its durability, lifespan, and cost effectiveness. While it is usually durable, it is also the kind of siding that is most fragile when it comes to extreme changes in the weather. Vinyl siding can become brittle when exposed to very cold weather. However, the primary issue of vinyl siding is usually found during hot days where it starts melting.

Why Does Vinyl Siding Melt?

One of the primary reasons why you can find melted vinyl siding in your home is because of the heat reflection from the windows. It usually happens during extreme heat or when you are using energy efficient window films. These types of films have properties that can prevent solar heat from entering the interior of the house. However, this also often leads to the solar heat being reflected back outside, which often causes melted vinyl siding.

When to Replace Your Melted Vinyl Siding?

There are several physical factors that you can see and easily identify if you already have melted vinyl siding. When you see these signs, then it is time to repair or replace your melted vinyl siding.

  • There are warped surfaces on the vinyl
  • There are cracks and breaks on the surface of the vinyl siding.

These damages in melted vinyl siding usually have a diagonal pattern, starting from the top and then goes downward.

How to Repair Melted Vinyl Siding

The melted vinyl siding, or siding thermal distortion, is usually not included in most siding warranties. This is why when you have this problem in your home, knowing a few practical ways to repair your melted vinyl siding can be very convenient options instead of paying a contractor a moderate sum to do it for you. Follow the steps below to repair melted vinyl sliding:

  • Pull out the nails that hold the first set of damaged vinyl siding to the wall.
  • Remove the damaged vinyl siding by pulling it down.
  • Remove all the melted vinyl siding by following the same steps.
  • Measure and cut new vinyl siding panels, making sure that it fits properly.
  • Snap the siding panel into the wall and secure with nails, start from the lowest course working your way to the top.
  • Don’t nail the siding panel to the wall too tightly, leave the head of the nail protruding.

While you can easily repair thermal siding distortion, the problem is that it will most probably come back when not addressed properly. Visit our website for more efficient ways to prevent melted vinyl siding.


Leave a comment

Please note, comments must be approved before they are published